Microsoft LPF-00004 Manual del operador descargar pdf (Pagina 86)

Page 68 CMD300 CONTROL SOFTWARE

YBER

380, COPYRIGHT MARCH 2002, AXON INSTRUMENTS, INC.

Entering an alphanumeric key as the first character of the command line will erase the previous

command line. Again, an <Esc> will restore the previous command line. Hit <Enter> to have the

program process the command line.

The output area of the screen displays the last few commands that were entered and the program's

response to each command.

Command-File Mode

In this mode the program reads commands from a disk file and sequentially processes them until the

end of the file is reached. The screen is again divided into an output area and an input area, but in this

case the input area is about 30% of the screen and scrolls throughout the text of the command file.

The processing of the command lines can be continuous or in step-mode under control of the

keyboard. The command file may contain continuous/step-mode commands to allow manual

intervention in command-file processing. By default, the command-file mode is commenced in

continuous mode but this may be over-ridden by a command on the command line.

CMD300 @SOMECMDS

CMD300 STEP @SOMECMDS

The first of the above invocations of CMD300 will automatically process the command lines in file

SOMECMDS.CMD until the end of the file is reached, or until processing is suspended by a "STEP"

command in the command file, or until processing is interrupted by an <Esc> from the keyboard. By

contrast, the second of the above invocations will cause the program to enter into command-file mode

and present the first command line in file SOMECMDS.CMD as the current command. Keyboard

input will be required before any commands are executed. Note that by default the command-file

extension is *.CMD.

When in Step mode, the user can also enter commands manually at any time by typing the desired

command and hitting <Enter> to process the command line. Note that the CONTINUOUS command

can be entered manually in Step mode to cause the switch to continuous mode. The user can also

move around in the command file by using the <Up>, <Down>, <PgUp>, <PgDn>, <Home>, and

<End> keys.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 156 157

Sin comentarios

Microsoft LPF-00004 Manual del operador Pagina 86