Microsoft LPF-00004 Manual del operador descargar pdf (Pagina 129)

PROGRAMMER'S GUIDE Page 111

YBER

380, COPYRIGHT MARCH 2002, AXON INSTRUMENTS, INC.

Example Programs

The following BASIC example programs illustrate the use of the CyberAmp support library to control

the CyberAmp.

The first program causes the CyberAmp to reload the factory defaults for the channel setup.

'The following INCLUDE statement is required to allow access to the

'routines that are exported by the C300LIB module.

'$include: 'C300LIBB.INC'

'Initialize the CyberAmp interface module.

if C300.Initialize% then

end if

'Set the CyberAmp device number.

'This step is not required if the device number is set to

'C300.DEVICENULL since this is the default. Therefore this step is

'included only for completeness.

if C300.SetDeviceNumber% (C300.DEVICENULL) then

print "Error setting CyberAmp device number:"; C300.GetLastError%

end

end if

'Set the CyberAmp COM port and baud rate.

if C300.SetOutput% (C300.COM1, C300.SPEED9600) then

print "Error setting CyberAmp port/speed:"; C300.GetLastError%

end

end if

'Load the factory defaults.

if C300.LoadFactoryDefaults% then

print "Error loading CyberAmp defaults:"; C300.GetLastError%

end

end if

'Now flush out the command queue to the CyberAmp.

if C300.FlushCommands% then

print "Error on flush command:"; C300.GetLastError%

end

end if

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 156 157

Sin comentarios

Microsoft LPF-00004 Manual del operador Pagina 129