Microsoft LPF-00004 Manual del operador descargar pdf (Pagina 34)

Page 16 TYPICAL CONFIGURATIONS

CYBERAMP 380, COPYRIGHT MARCH 2002, AXON INSTRUMENTS, INC.

Almost any A/D interface can be used. The Digidata 1322A and previous interfaces from Axon

Instruments are suitable, as are interfaces from many other manufacturers. Almost any computer type

is acceptable (with appropriate software), because nearly all computers support RS-232 serial

communications. Null modem cables suffice for the communications link, but the RS232-01 cable

from Axon Instruments is specifically designed for this task. Complete wiring information for the

cable is given in Appendix A for those users who wish to make their own cable.

A wide variety of software programs can be used for data acquisition. Some may not directly control

the CyberAmp. In these cases, to the included CyberControl for Windows or Macintosh software can

be used, or for DOS, run the CMD300 or Quick 300 programs.

The computer control of the CyberAmp 380 is maximally beneficial when the software directly

controls the CyberAmp. Axon Instruments' AxoScope and pCLAMP data acquisition software are

designed to provide flexible control of the CyberAmp and ease of use. Many other vendors have

expressed their intention to similarly support the CyberAmp. If special purpose software is being

written, the library routines provided with the CyberAmp should make the task a simple one.

Several other acquisition system setups that rely on the CyberAmp 380 are shown in Figures 4-7.

Figure 4. In this variation, two CyberAmp 380s are used to control 16 data channels. An RS232-02 expansion

cable from Axon Instruments, or equivalent, is used to add the second CyberAmp to the serial communications port.

The first unit is given address "1" and the second address "2". The addresses need not be numbers 1 and 2, but

they must not be the same number.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 156 157

Sin comentarios

Microsoft LPF-00004 Manual del operador Pagina 34