Microsoft Computer Hardware System Board Manual de usuario descargar pdf (Pagina 23)

Hardware Installation

2.7.6 USB Ports

The system board is equipped with a header at location J11 on the

system board, for external USB ports. USB allows data exchange

between your computer and a wide range of simultaneously

accessible external Plug and Play peripherals.

You must have the proper drivers installed in your operating system

to use these ports. Refer to your operating systems manual or

documentation.

Connecting the USB Ports

As an option, one card-edge bracket mounted with two USB port

cables may be provided with the system board. The ends of the

cables are attached to a connector. Connect the USB cable

connector to J11 on the system board. The USB port cables can be

inserted only if pin 1 of the cable (red wire) is aligned with pin 1 of

J11. Pin 9 of J11 has been removed and the hole in the USB cable

connector, which corresponds to pin 9, has been plugged to prevent

incorrectly inserting the connector. Mount the card-edge bracket to

the system chassis.

Function

+5V

-Data

+Data

Ground

Key

Function

+5V

-Data

+Data

Ground

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Sin comentarios

Microsoft Computer Hardware System Board Manual de usuario Pagina 23