Microsoft Windows NT 4.0 Guide Guía de usuario descargar pdf (Pagina 101)

Chapter 4 Using the Microcal Diagnostic Utility 101

3. Type N to view the noise levels without changing the current

frequency. The following screen appears:

4. Touch the box in the lower right corner and hold your finger to the

screen.

5. Observe the fluctuating bars in the Percent Noise plots. Look at

the peak noise plot with the current setting, and then try other

frequency levels. The best setting is usually between 0 and 1.0.

6. Press F10 to hold the bar at peak.

The objective is to reduce the peak and average noise levels in these

plots by changing the frequency.

Continue to adjust the frequency until you find the best setting. If you

can obtain a good performance at many frequencies, choose the

highest frequency to obtain optimum performance. In general, a

higher frequency produces a stronger signal.

If you still need to adjust the frequency, press Esc to return to the

Noise Check screen.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 143 144

Sin comentarios

Microsoft Windows NT 4.0 Guide Guía de usuario Pagina 101