Microsoft Windows NT 4.0 Guide Manual de usuario descargar pdf (Pagina 15)

Chapter 2 Installation 2-3

Configuring the Fibre Channel Host Bus

Adapter

Configure the Fibre Channel host bus adapter, if applicable:

1. Power on your Windows NT host and your disk array.

■ If you see a message prompting you to press Alt-Q to launch the Qlogic

Fast!UTIL, your Fibre Channel host bus adapter has BIOS on it. Continue with

this procedure to configure your host bus adapter.

■ If you don’t see such a message, proceed to next section, “Installing the Fibre

Channel Driver on the Windows NT Host” on page 2-4.

2. Respond to the prompt by pressing Alt-Q.

3. Select Configuration Settings and then press Enter.

4. Select Host Adapter Settings and then press Enter.

5. Select Host Adapter BIOS and make sure that the setting is Disabled; if

necessary, press the Enter key to toggle the setting. (Disabling the host adapter

BIOS disables the ROM BIOS and frees space in upper memory.)

6. Press the Escape key twice.

7. Select Save Changes and then press Enter.

8. Select Exit Fast!UTIL and then press Enter.

9. Select Reboot system and then press Enter.

10. Continue with the next section, “Installing the Fibre Channel Driver on the

Windows NT Host”.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Microsoft Windows NT 4.0 Guide Manual de usuario Pagina 15